Research on the Hydrodynamic Characteristics of a Rectangular Otter Board in Different Work Postures Based on a Dynamic Model

Abstract

This paper investigates the hydrodynamic characteristics of a rectangular otter board in different working postures by using a dynamic model. Dynamic models are mainly based on dynamic mesh techniques. The results of the dynamic model are, compared to the model test, carried out in a flume tank. Furthermore, different rotation speeds of dynamic model were analyzed. The research results are as follows: compared to flume tank results, the maximum error of the dynamic model is 23.77%. Moreover, the influence of rotation speed on the hydrodynamic board is not obvious, and 2 deg./s was chosen as the rotation speed. When the board is tilted slightly (including four working postures), its lift-to-drag ratio first increases slightly and then gradually decreases. Compared with the other three working postures, the pressure center coefficient of the board does not change significantly when it is tilted inward. When studying different working angles (including AOA and tilt angle) of the otter board, the numerical dynamic model significantly reduces repetitive setup work, making simulations more efficient. Its ability to provide continuous curves and a large volume of results offers researchers a more detailed and comprehensive understanding of the board’s hydrodynamics. Additionally, the dynamic model supports innovative fishery equipment development by allowing more accurate and continuous numerical simulations.

Bibliographic Information