Comparative Study on Alternative Umbilical Cable Configurations for Deep-Sea Mining System

Abstract

The umbilical cable plays a critical role in deep-sea mining systems by connecting the surface support vessel to the mining vehicle. If the spatial configuration of the umbilical cable is unsuitable for mining vehicle operations, it may experience overloading, slack, seabed contact, or be run over by the mining vehicle. To address these issues, this study focuses on double-stepped, steep-wave, and S-shaped configurations and develops a coupled dynamic model of the surface support vessel–umbilical–mining vehicle system using the lumped-mass method, which incorporates hydrodynamic loads induced by currents and irregular waves, as well as motion excitations from the surface support vessel. The spatial configurations and mechanical responses of three umbilical configurations were evaluated, including maximum effective tension, lateral drift amplitude, and the mining vehicle’s overturning moment. The results indicate that the double-stepped configuration offers superior performance in terms of ground clearance, effective tension, and collaborative operation of the mining vehicle, although it faces an increased risk of fatigue failure due to dual buoyancy sections. The S-shaped configuration exhibits improved control of lateral drift and bending response under ocean current excitation, while the steep-wave configuration demonstrates intermediate behavior. In addition, the study analyzed the local compression of the umbilical cable and the variation trends of the mining vehicle’s overturning moments. These findings offer insights into the optimization of umbilical design and operational parameters, enhancing the safety, reliability, and efficiency of deep-sea mining systems.

Bibliographic Information